A decorative end wedge hides the seam between the sides at the lower bout. This video excerpt from the Online Guitar Building School goes into detail about design considerations and the process for creating a clean and attractive endwedge. Video Transcript: Okay, the sides are looking pretty good at this point. The addition of a […]
To follow up episode #22 When a Bridge Removal Goes Bad, I decided to also write an article on bad neck removals as well. This neck removal was particularly hairy. I won’t get into why this was the case, but you can see the damage to the soundboard beneath the fretboard tongue was extensive! […]
When I first started building guitars, I remember some of the difficulty that I had in cutting the headplate square to the nut slot. I would clamp a piece of scrap wood to the headplate as a fence, but the fence would only keep me square to the sides. To get the edge of the […]
This Martin 000-15 came into my shop with a long split in the sides on the treble side. The owner told me that the guitar was never dropped or bumped into anything. It never experienced any kind of trauma to cause the split. Furthermore, the guitar had been repaired previously for splits in the sides, also […]
For this episode I am using an excerpt of The Online Guitar Building School’s Building an OM Acoustic series. This video walks you through the construction of upper, waist, and lower bout spreaders to fit your guitar mold. Was this useful? I would love to hear your questions or comments! I try to answer every e-mail […]
My Canadian friend brought me a Norman guitar with a lifting bridge, a belly bulge, and long run-out splits in the soundboard beginning just forward of the belly bulge. These are all symptoms of the same problem: too much tension at the bridge. First, the bulge in the belly needed to be reduced, then the bridge removed […]
Quartersawn Vs. Flatsawn: Guitar Bracing This is an excerpt from “Roughing Out the Braces” https://ericschaeferguitars.com/course/building-an-om-acoustic/ Transcript: Now we are going to rough out our brace blanks from billets of spruce. Before we get started with that we just need to understand the difference between quarter sawn and flat sawn. To get a better understanding of […]
*This is an inside look at The May 2015 Acoustic Guitar Workshop at Eric Schaefer Guitars. The class is an 8 day intensive course in Guitar Making with a maximum of only 2 students to a class. For more information on the courses go to Guitar Making Classes. In May of 2015 Chris (left) and Jim(right) built […]
In part I of “Acoustic Guitar Design: An Insight into the Choices Made by Luthiers” I discussed body dimensions, scale length, string spacing, fretboard radius, neck profiles, fretwire size, wood selection and bracing. It was a very superficial glimpse into a number of complex topics. So much so that it is worthy of this disclaimer: *Disclaimer: This […]
Spoiler alert. The correct answer is… You can never have too many! This is no longer a statement of opinion, but rather a statement of fact, as evidenced by this trucker hat: It is safe to say that the question of “how many clamps” is not a point of contention in the woodworking […]
