Course Syllabus Units & Lessons Getting Started Introduction Materials and Parts Tools Jigs The Plates Jointing the Plates Joining the Plates Thicknessing the Plates Making the Rosette Installing the Rosette Roughing Out the Braces Soundboard Bracing Back Bracing Brace Carving The Sides Bending the Sides Attaching the Neckblock and Endblock Radiusing and Kerfing the Sides Side Bracing The End Wedge The Neck – Part 1 Cutting the Scarf Joint Gluing the Scarf Joint and the Heelblock Routing the Truss Rod Channel Attaching the Headplate Routing the Headstock Shape Drilling and Fitting Tuner Holes The Heelcap The Fretboard and The Bridge Fret Slotting Tapering the Fretboard and Shaping the End Inlaying Position Markers Roughing out the Bridge The Soundbox Fitting the Back Plate Gluing the Back Plate Fitting and Gluing the Soundboard Trimming Overhang Cutting Binding and Purfling Channels Installing Binding and Purfling The Neck – Part 2 The Mortise and Tenon Installing the Truss Rod and Clearing for the Truss Rod Extension Installing Threaded Inserts into the Tenon Attaching the Fretboard Hand Carving the Neck Neck Fitting Final Assembly Attaching the Neck Locating and Gluing The Bridge Levelling and Radiusing the Fretboard Installing Frets Over the Body Bevelling and Dressing Fret Ends Levelling the Bridge Fitting the Nut Cutting the Saddle Slot Refining the Bridge Shape Fitting and Shaping the Saddle Bridge Pin Fitting Nut Slotting Final Setup Tuning to Pitch Neck Relief Adjusting the Action at the Nut and Saddle Intonation Finishing Wood Prep Pore Filling Applying Coats Buffing
